摘要： Laser micromilling technique is used to manufacture microchannel on metals and nonmetals. Microfeatures ≤100 μm are still challenging for fabrication by common methods. Nanosecond fiber laser micromachining has become more popular owing to its prospective implementation in laser micromilling. Microchannel application relies on its geometric dimension, profile, and surface quality. In this study, an attempt was made to explore the impact of process parameters scanning times, scanning velocity, pulse repetition rate, and assist gas pressure on top kerf width, taper, surface roughness, and metal removal rate in laser micromilling experimentally. Microchannel width varied between 45.5 and 70.9 μm. A regression model has been developed for each response. ANOVA (analysis of variance) has been carried out to remove insignificant parameters. Thermal stress analyzed by surface cracks inside microchannel by Scanning Electrone Microscopy (SEM) images. Higher PRR, lower no. of scans, higher scanning speed and high air pressure found suitable for lesser surface cracks. Redeposition observed at slower scanning velocity and minimum scanning times. Oxidation zone from boundary of channel varies between 37 and 58 μm. Oxide formed on Ti surface which increases oxygen content toward center of channel from 51.08 to 76.22% compared to outside surroundings.