研究目的
To develop a nanogap capacitive biosensor that minimizes electrode polarization effects, enabling sensitive and selective label-free detection of proteins such as human alpha thrombin using impedance spectroscopy.
研究成果
The nanogap capacitive sensor effectively reduces electrode polarization effects, allowing low-frequency measurements for biosensing. It demonstrates high specificity and sensitivity for thrombin detection using aptamer functionalization. The dielectric response of confined fluids shows unusual behaviors, such as increased permittivity with ionic strength and potential ice-like phases, highlighting the need for further study in nanoscale fluid dynamics.
研究不足
The yield of successful devices during fabrication is currently low (about 15%), and improvements are needed in electrode adhesion and robustness. The study did not investigate detection limits and sensitivity in detail, and the nature of dielectric response in nanogaps is not fully understood, requiring further research.
1:Experimental Design and Method Selection:
The study involved designing a horizontal thin-film nanogap capacitive sensor with 40 nm electrode separation to reduce electrode polarization effects. Standard photolithography and etching techniques were used for fabrication. Impedance spectroscopy was employed to measure dielectric properties.
2:Sample Selection and Data Sources:
Samples included de-ionized water, saline-sodium citrate (SSC) buffer solutions at various concentrations (0.1x to 1x SSC), and human alpha thrombin protein. Aptamers and control oligonucleotides were used for surface functionalization.
3:1x to 1x SSC), and human alpha thrombin protein. Aptamers and control oligonucleotides were used for surface functionalization.
List of Experimental Equipment and Materials:
3. List of Experimental Equipment and Materials: Equipment included an HHV Auto 500 e-beam evaporator for metal deposition, RF magnetron sputtering for SiO2 deposition, Solartron 1260 impedance analyzer, Solartron 1296 dielectric interface, and Stanford SR830 Lock-in amplifier. Materials included quartz substrates, photoresists (AZ5214E), metals (chromium, gold), SiO2, HF etchant, thiol-modified aptamers, mercaptohexanol (MCH), and thrombin protein.
4:Experimental Procedures and Operational Workflow:
Fabrication involved cleaning substrates, depositing bottom electrodes via photolithography and lift-off, sputtering a 40 nm SiO2 layer, depositing top electrodes, and etching the SiO2 to form the nanogap. Surface functionalization involved incubating devices with aptamers and MCH. Protein detection involved incubating with thrombin, washing, and measuring capacitance changes. Impedance measurements were taken from 10 Hz to 600 kHz.
5:Data Analysis Methods:
Relative permittivity was calculated from capacitance measurements using a derived equation. Data were analyzed for flat responses indicating absence of electrode polarization and shifts due to protein binding.
独家科研数据包,助您复现前沿成果,加速创新突破
获取完整内容