- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Study of the phase composition and tribological properties of carbon tool steels after laser surface hardening by quasi - CW fiber laser
摘要： The paper contains the investigation results on the structure and phase composition of the laser radiation area (LRA) of the U8 and U10 steels over its entire thickness. In the present study, the laser surface hardening of both U8 (ASTM - W1-7) and U10 (ASTM - W1-9) steels in the air was performed by exploiting a quasi - CW fiber laser with a 130 W power and 3 mm/s processing speed. The phase composition of the oxide layer formed as a result of laser treatment (LT) in air, as well as the structure of the oxide-metal interface on the surface of U8 (ASTM–W1-7) and U10 (ASTM–W1-9) carbon tool steels were studied by X-ray photoelectron spectroscopy (XPS). It was established that the thickness of the completely oxidized surface layers for U8 and U10 steels is 38.7 nm and 99 nm, respectively. The composition of the oxides of the steel surface after LT was determined. The presence of a wüstite-based film on U8 steel evidences the low wear properties of the LRA surface, while the thicker oxide layer of the modified U10 steel which contains Fe2O3 and Fe3O4 oxides with better strength properties, on the contrary, provides U10 steel surface with higher wear resistance. It was found that the wear rate of U10 steel modified surface decreases by more than two times, while the given value for U8 steel reduces no more than 17%. The paper reports the metallographic examination of the LRA structure. It was shown that the wear-resistant structural components that appeared after laser treatment lead to an increase in the deformation properties of steels. The maximum microhardness value of the LRA is 710 HV0.1 for U8 steel and 750 HV0.1for U10 steel.
关键词： Laser radiation,Oxidized surface layers,X-ray photoelectron spectroscopy,Phase composition,Surface finishing treatment,Elemental composition
更新于2025-09-19 17:13:59
-
Comparison of Calibration Approaches in Laser-Induced Breakdown Spectroscopy for Proximal Soil Sensing in Precision Agriculture
摘要： The lack of soil data, which are relevant, reliable, a?ordable, immediately available, and su?ciently detailed, is still a signi?cant challenge in precision agriculture. A promising technology for the spatial assessment of the distribution of chemical elements within ?elds, without sample preparation is laser-induced breakdown spectroscopy (LIBS). Its advantages are contrasted by a strong matrix dependence of the LIBS signal which necessitates careful data evaluation. In this work, di?erent calibration approaches for soil LIBS data are presented. The data were obtained from 139 soil samples collected on two neighboring agricultural ?elds in a quaternary landscape of northeast Germany with very variable soils. Reference analysis was carried out by inductively coupled plasma optical emission spectroscopy after wet digestion. The major nutrients Ca and Mg and the minor nutrient Fe were investigated. Three calibration strategies were compared. The ?rst method was based on univariate calibration by standard addition using just one soil sample and applying the derived calibration model to the LIBS data of both ?elds. The second univariate model derived the calibration from the reference analytics of all samples from one ?eld. The prediction is validated by LIBS data of the second ?eld. The third method is a multivariate calibration approach based on partial least squares regression (PLSR). The LIBS spectra of the ?rst ?eld are used for training. Validation was carried out by 20-fold cross-validation using the LIBS data of the ?rst ?eld and independently on the second ?eld data. The second univariate method yielded better calibration and prediction results compared to the ?rst method, since matrix e?ects were better accounted for. PLSR did not strongly improve the prediction in comparison to the second univariate method.
关键词： laser-induced breakdown spectroscopy,soil nutrients,elemental composition,proximal soil sensing,LIBS
更新于2025-09-12 10:27:22
-
Archaeological applications of spectroscopic measurements. Compatibility of analytical methods in comparative measurements of historical Polish coins
摘要： The ED-XRF (energy-dispersive X-ray fluorescence) compact system was used to analyze selected Polish historical coins. The compact X-ray tube developed in the National Centre for Nuclear Research (NCBJ) was used as an X-ray source in the system designed for the ED-XRF studies. The XRF spectra were recorded with the Amptek SDD spectrometer. The elemental compositions of the coins have been determined using above mentioned system and the results were compared to those obtained with WD-XRF method. Other techniques such as SEM-EDX and XRD were also included into this work for comparison. The experimental data show that the X-ray system with transmission type X-ray tube with silver anode operating at 50 kV/30 mA which was developed in NCBJ together with the Amptek SDD spectrometer is an effective tool for chemical composition analyze of historical coins and can be successfully used in archaeometry.
关键词： Elemental composition,Energy-dispersive X-ray fluorescence,X-ray powder diffraction,Scanning electron microscope with Energy Dispersive X-Ray Spectroscopy,Wavelength-dispersive X-ray fluorescence
更新于2025-09-04 15:30:14