- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
A new laser-based and ultra-portable gas sensor for indoor and outdoor formaldehyde (HCHO) monitoring
摘要： In this work, a new commercially available, laser-based, and ultra-portable formaldehyde (HCHO) gas sensor is characterized, and its usefulness for monitoring HCHO mixing ratios in both indoor and outdoor environments is assessed. Stepped calibrations and intercomparison with well-established laser-induced fluorescence (LIF) instrumentation allow a performance evaluation of the absorption-based, mid-infrared HCHO sensor from Aeris Technologies, Inc. The Aeris sensor displays linear behavior (R2 > 0.940) when compared with LIF instruments from Harvard and NASA Goddard. A nonlinear least-squares fitting algorithm developed independently of the sensor’s manufacturer to fit the sensor’s raw absorption data during post-processing further improves instrument performance. The 3σ limit of detection (LOD) for 2, 15, and 60 min integration times are 2190, 690, and 420 pptv HCHO, respectively, for mixing ratios reported in real time, though the LOD improves to 1800, 570, and 300 pptv HCHO, respectively, during post-processing. Moreover, the accuracy of the sensor was found to be ± (10 % + 0.3) ppbv when compared against LIF instrumentation sampling ambient air. The aforementioned precision and level of accuracy are sufficient for most HCHO levels measured in indoor and outdoor environments. While the compact Aeris sensor is currently not a replacement for the most sensitive research-grade instrumentation available, its usefulness for monitoring HCHO is clearly demonstrated.
关键词： outdoor monitoring,gas sensor,ultra-portable,HCHO,indoor monitoring,formaldehyde,laser-based
更新于2025-09-23 15:19:57
-
Hierarchical WO3/ZnWO4 1D fibrous heterostructures with tunable in-situ growth of WO3 nanoparticles on surface for efficient low concentration HCHO detection
摘要： Hierarchical WO3/ZnWO4 1D fibrous heterostructures with tunable in-situ growth of WO3 nanoparticles on surface have been fabricated by the original one-step electrospinning technology combined with subsequent calcination process. Phase composition and morphology can be transformed from bead-like WO3 fibers to hierarchical WO3/ZnWO4 1D composites with the introduction of ZIF-8 into the precursor solution, which was mainly attributed to the combination of nucleation competition and crystal planes matching mechanisms during heat treatment. Compared with pure WO3 and WO3/ZnWO4-10%, WO3/ZnWO4-5% displayed the highest specific surface area value evaluated to be 268.57, indicating the prominent enhanced absorption behavior for targeted organic species. It is found that WO3/ZnWO4-5% composites have a response about 44.5 for 5 ppm HCHO, which was almost 8 times higher than that of sensor based on pure WO3 nanofibers at the optimal operating temperature. Meanwhile, the fast response/recovery time (12/14 s) and excellent stability characteristics (recycling, long-term, and humidity stability) towards HCHO can be also observed for WO3/ZnWO4-5% samples. The enhanced gas-sensing mechanism based on WO3/ZnWO4 composites can be ascribed to the synergistic effect of effective heterojunctions, large specific surface area, multiple reaction sites, and unique surface/interface electron transmission. The design and construction of hierarchical WO3/ZnWO4 1D materials attest to the significant potential of their use as novel gas sensors for detecting low concentration HCHO.
关键词： electrospinning,gas sensors,in-situ growth,HCHO,WO3/ZnWO4 heterostructures
更新于2025-09-19 17:15:36
-
Pyrochlore Ca-doped Gd2Zr2O7 solid state electrolyte type sensor coupled with ZnO sensing electrode for sensitive detection of HCHO
摘要： Solid state electrolyte type formaldehyde (HCHO) gas sensors based on a novel pyrochlore structure Gd2Zr2O7 solid electrolyte coupled with rod-shaped ZnO sensing electrode (SE) were initially designed and fabricated in this paper. The incorporation of alkaline-earth metal Ca can signi?cantly improve sensing performance of the Gd2Zr2O7 based sensors to HCHO. The response value (ΔV) of the sensors based on Gd2-xCaxZr2O7 (x = 0, 0.02, 0.05 and 0.1) varied approximately linear with the logarithm of HCHO concentration in the range of 1?100 ppm at 600 °C, with sensitivities of -25, -30, -15 and -5 mV/decade, respectively. The optimal sensor based on Gd1.98Ca0.02Zr2O7 (GCZ(0.02)) exhibited the excellent sensing characteristics with maximum response value (-61.3 mV) and extremely short response time (3 s) to 100 ppm HCHO. In addition, the GCZ(0.02) sensor also showed good selectivity and stability within 20-day period of continuous high-temperature aging under high-humidity condition. Conclusively, the sensing behavior and mechanism based on mixed potential were investigated and demonstrated by the mearsurement of the polarization curves.
关键词： Ca-doped Gd2Zr2O7,Rod-shaped ZnO,HCHO sensor,Pyrochlore solid electrolyte
更新于2025-09-19 17:13:59
-
Tropospheric NO<sub>2</sub>, SO<sub>2</sub>, and HCHO over the East China Sea, using ship-based MAX-DOAS observations and comparison with OMI and OMPS satellite data
摘要： In this study, ship-based multi-axis differential optical absorption spectroscopy (MAX-DOAS) measurements were performed in the East China Sea (ECS) area in June 2017. The tropospheric slant column densities (SCDs) of nitrogen dioxide (NO2), sulfur dioxide (SO2), and formaldehyde (HCHO) were retrieved from the measured spectra using the differential optical absorption spectroscopy (DOAS) technique. Using the simple geometric approach, the SCDs of different trace gases observed at a 15? elevation angle were adopted to convert into tropospheric vertical column densities (VCDs). During this campaign, the averaged VCDs of NO2, SO2, and HCHO in the marine environment over the ECS area are 6.50 × 1015, 4.28 × 1015, and 7.39 × 1015 molec cm?2, respectively. In addition, the ship-based MAX-DOAS trace gas VCDs were compared with satellite observations of the Ozone Monitoring Instrument (OMI) and Ozone Mapping and Profiler Suite (OMPS). The daily OMI NO2 VCDs agreed well with ship-based MAX-DOAS measurements showing the correlation coefficient R of 0.83. In addition, the good agreements of SO2 and HCHO VCDs between the OMPS satellite and ship-based MAX-DOAS observations were also found, with correlation coefficients R of 0.76 and 0.69. The vertical profiles of these trace gases are achieved from the measured differential slant column densities (DSCDs) at different elevation angles using the optimal estimation method. The retrieved profiles displayed the typical vertical distribution characteristics, which exhibit low concentrations of < 3, < 3, and < 2 ppbv for NO2, SO2, and HCHO in a clean area of the marine boundary layer far from coast of the Yangtze River Delta (YRD) continental region. Interestingly, elevated SO2 concentrations can be observed intermittently along the ship routes, which is mainly attributed to the vicinal ship emissions in the view of the MAX-DOAS measurements. Combined with the onboard ozone lidar measurements, the ozone (O3) formation was discussed with the vertical profile of the HCHO/NO2 ratio, which is sensitive to increases in NO2 concentration. This study provided further understanding of the main air pollutants in the marine boundary layer of the ECS area and also benefited the formulation of policies regulating the shipping emissions in such costal areas like the YRD region.
关键词： OMPS,SO2,East China Sea,MAX-DOAS,HCHO,OMI,NO2
更新于2025-09-10 09:29:36
-
Observing atmospheric formaldehyde (HCHO) from space: validation and intercomparison of six retrievals from four satellites (OMI, GOME2A, GOME2B, OMPS) with SEAC<sup>4</sup>RS aircraft observations over the Southeast US
摘要： Formaldehyde (HCHO) column data from satellites are widely used as a proxy for emissions of volatile organic compounds (VOCs), but validation of the data has been extremely limited. Here we use highly accurate HCHO aircraft observations from the NASA SEAC4RS campaign over the Southeast US in August–September 2013 to validate and intercompare six operational and research retrievals of HCHO columns from four different satellite instruments (OMI, GOME2A, GOME2B and OMPS) and three different research groups. The GEOS-Chem chemical transport model provides a common intercomparison platform. We find that all retrievals capture the HCHO maximum over Arkansas and Louisiana, reflecting high emissions of biogenic isoprene, and are consistent in their spatial variability over the Southeast US (r=0.4–0.8 on a 0.5o×0.5o grid) as well as their day-to-day variability (r=0.5–0.8). However, all satellite retrievals are biased low in the mean by 20–51%, which would lead to corresponding bias in estimates of isoprene emissions from the satellite data. The smallest bias is for OMI-BIRA, which has the highest corrected slant columns and the lowest scattering weights in its air mass factor (AMF) calculation. Correcting the assumed HCHO vertical profiles (shape factors) used in the AMF calculation would further reduce the bias in the OMI-BIRA data. We conclude that current satellite HCHO data provide a reliable proxy for isoprene emission variability but with a low mean bias due both to the corrected slant columns and the scattering weights used in the retrievals.
关键词： SEAC4RS,OMPS,isoprene emissions,validation,satellite retrievals,HCHO,GEOS-Chem,Formaldehyde,GOME2B,OMI,GOME2A
更新于2025-09-04 15:30:14
-
Tropospheric NO<sub>2</sub>, SO<sub>2</sub>, and HCHO over the East China Sea, using ship-based MAX-DOAS observations and comparison with OMI and OMPS satellites data
摘要： In this study, ship-based Multi-Axis Differential Optical Absorption Spectroscopy (MAX-DOAS) measurements were performed in the Eastern China Sea (ECS) area in June 2017. The tropospheric Slant Column Densities (SCDs) of nitrogen dioxide (NO2), sulfur dioxide (SO2), and formaldehyde (HCHO) were retrieved from the measured spectra by the Differential Optical Absorption Spectroscopy (DOAS) technique. Using the simple geometric approach, the SCDs of different trace gases observed at 15° elevation angle were adopted to convert into tropospheric Vertical Columns Densities (VCDs). During this campaign, the averaged VCDs of NO2, SO2, and HCHO in the marine environment over ECS area are 6.50 × 1015 molec cm-2, 4.28 × 1015 molec cm-2 and 7.39 × 1015 molec cm-2, respectively. In addition, the ship-based MAX-DOAS trace gases VCDs were compared with satellite observations of Ozone Monitoring Instrument (OMI) and Ozone Mapping and Pro?ler Suite (OMPS). The daily OMI NO2 VCDs agree well with ship-based MAX-DOAS measurements showing the correlation coefficient R of 0.83. Besides, the good agreements of SO2 and HCHO VCDs between the OMPS satellite and ship-based MAX-DOAS observations were also found with correlation coefficient R of 0.76 and 0.69. The vertical profiles of these trace gases are achieved from the measured Differential Slant Column Densities (DSCDs) at different elevation angles using optimal estimation method. The retrieved profiles displayed the typical vertical distribution characteristics, which exhibits the low concentrations of < 3, < 3, and < 2 ppbv for NO2, SO2, and HCHO in clean area of the marine boundary layer far from coast of the Yangtze River Delta (YRD) continental region. Interestingly, elevated SO2 concentrations can be observed intermittently along the ship routes, which is mainly attributed to the vicinal ship emissions in the view of the MAX-DOAS measurements. Combined with the on-board ozone lidar measurements, the ozone (O3) formation was discussed with the vertical profile of HCHO/NO2 ratio, which is sensitive to the increases of NO2 concentration. This study provided further understanding of the main air pollutants in the marine boundary layer of the ECS area and also benefited to formulate the policies regulating the shipping emissions in such costal area like YRD region.
关键词： NO2,SO2,OMI,MAX-DOAS,OMPS,ship-based observations,HCHO,East China Sea
更新于2025-09-04 15:30:14