- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
An interferometric structure with a dual-resonance long period grating for strain sensing
摘要： Spectral characteristics and amplitude tunability of a long period grating with a dual-resonance inside fiber loop mirror are studied in terms of applied stress caused by elongation. Inserting the polarization controller between grating and part of polarization maintaining fiber in the loop structure enables tuning of resonance and interferometric peaks. The maximum sensitivity of demonstrated sensor is of 1.943 dB/mε for the range of 1.1–4.4 mε. Combination of these two optical components allows to measure strain in a wider range comparing with sensors based on standard long period grating.
关键词： Fiber loop mirror,Polarization controller,Polarization maintaining fiber,Strain sensor,Long period grating
更新于2025-09-23 15:23:52
-
Tailorable and Flexible Conducting Films via Interfacial Modification of Polymer Fibers
摘要： Portable devices have become lightweight, flexible, and even stretchable such that skin-like electronics are widely applicable, including in biomedical devices, soft robotics, and human/machine interfaces. Rendering these devices soft and flexible is highly desirable, as this would enable them to interact seamlessly with human skin and improve their wearing comfort. We demonstrate a convenient but effective method to fabricate flexible conducting films. These films consist of electrospun polyurethane (PU) fibers as the flexible substrate onto which copper was deposited. These Cu-PU films have excellent conductivity, and their resistance only increases slightly after extensive folding, even when folded into a paper crane with a resistance of 1.8 Ω. Furthermore, Cu-PU films can sense tension strength and exhibit stable Joule electrothermal performance. The Cu-PU-based heating glove could be heated to 40 °C in 30 s by applying 2 V. The simple but effective procedure presented here is suitable to fabricate flexible conducting film and may also promote the development of portable and flexible electronic products.
关键词： flexible,polymer fiber,strain sensor,conductive,interfacial modification
更新于2025-09-23 15:22:29
-
[IEEE 2019 Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC) - Munich, Germany (2019.6.23-2019.6.27)] 2019 Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC) - The Photonic Guitar Pickup: A High-Sensitivity, High-Bandwidth Fiber Strain Sensor
摘要： The photonic guitar pickup: a high-sensitivity, high-bandwidth fiber strain sensor. Fiber-strain sensors have found numerous applications from structural health monitoring for vibrations, to pressure and temperature sensing. Many of these sensors exploit the strain-sensitivity of the reflection wavelength of fiber-bragg gratings, (cid:83)-shifted gratings or other waveguide devices. The strain is typically inferred from a change of reflected or transmitted light intensity. Light intensity measurements are not very robust and have an inherently limited accuracy. We propose that a frequency-based strain measurements using fiber Fabry-Perot (FFP) cavities provide not only superior sensitivity but also retain a very high measurement bandwidth. Here, we present a fiber optic vibration sensor based on an FFP cavity, which consists of a matched pair of 23 dB fiber Bragg gratings coupled to a custom-built signal processing circuit. The wavelength of a laser diode is locked to one of the many cavity resonances using the Pound–Drever–Hall scheme. We demonstrate that such a strain sensor has an ultrawide dynamic sensing range, from less than 1 Hz to clinical ultrasound frequencies near 6 MHz. Its linear sensitivity range extends from below 1 n(cid:72) to 2 (cid:80)(cid:72), and its dynamic response limit is as high as 12 m(cid:72)/s. To demonstrate the high fidelity of the strain measurements we attached the FFP cavity sensor to the top plate of an acoustic guitar and recorded several melodies. As expected the sensor system was largely immune to noise arising from optical intensity fluctuations. We made distortion-free audio recordings of musical pieces from infrasound (~8 Hz) to 30 kHz with a 50 dB dynamic range in acoustic power. The remaining noise in our measurements arises from electronic sources and not optical sources, giving hope that future developments may be able to further increase the dynamic range of the measurements, if needed. In separate experiments the same sensor was affixed to the rim of a wineglass and to the side of a steel cantilever to monitor the (photo-)acoustic response of these mechanical resonators to periodic photo-excitation. We found, for example, that the limit of detection for orthophosphate through the photoacoustic excitation of the respective molybdenum-blue complex was below 2 ppm. Finally, the sensor was embedded in tissue phantoms to validate that it accurately responds to low frequencies (heart beat) and high frequencies (ultrasound pulse). In its most recent version the laser driver and the PDH circuit are addressed through a Raspberry-Pi microcontroller, making the sensor system very compact and relatively inexpensive. We propose that sensor systems based on PDH-interrogated FFP-sensor heads are robust and versatile for a large variety of monitoring applications.
关键词： Fabry-Perot cavity,vibration sensor,dynamic range,Pound–Drever–Hall scheme,fiber strain sensor
更新于2025-09-11 14:15:04