- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Fe3O4/SiO2 Core Shell Nanostructures: Preparation and Characterization
摘要： Silica coated iron oxide nanoparticles with controlled silica shell thickness were prepared by a modified St?ber method. Modification of the St?ber method consisted of changing the synthesis conditions to control the thickness of the SiO2 shell. The core-shell nanoparticles were characterized by means of X-ray diffraction, transmission electron microscopy, Fourier-transform infrared spectroscopy and vibrational sample magnetometry. It was found that the shell formed after 8 hours of stirring. An increase of the tetraethoxysilane-magnetite mass ratio from 12.5 to 25.1 led to an increase of the shell thickness, whereas further increase in the tetraethoxysilane-magnetite mass ratio (from 25.1 to 37.6) led to decrease shell thickness. The core size has only insignificant influence on the shell thickness. Magnetic properties of composite particles correlate well with properties of pure magnetite nanoparticles considering dilution of magnetic particles by silica. Obtained results can be used for fabrication of silica shell with controlled thickness on the surface of different sized magnetite nanoparticles.
关键词： FTIR,iron oxide,surface functionalization,silica coated,nanoparticles
更新于2025-09-04 15:30:14
-
Study on the Synthesis of GO-AgNP Mixture Assisted by AgNP Based on UV-Vis, SEM-EDX, XRD, and FTIR
摘要： This study aims to determine the effect of silver nanoparticles (AgNP) towards graphene oxide-silver nanoparticles (GO-AgNP) formation using liquid sonication exfoliation (LSE) method. The synthesis results are characterized using UV-Vis spectroscopy, scanning electron microscope (SEM-EDX), X-ray diffraction (XRD), and Fourier transform infra-red (FTIR) spectroscopy. This research begins by making two type of solutions. The first solution is AgNO3 solution which is being varied in concentration, i.e.: 1 mM, 2 mM, 3 mM, and 4 mM. The second solution is the graphite solution. Via the LSE method, AgNO3 that has been heated into becoming AgNP solution is mixed with the graphite solution. The mixture is subjected to 6 hours of ultrasonication. From this study GO or rGO material has been produced through the assistance of AgNP solution by varying the concentration of the AgNO3 solution. The UV-Vis result for 4 mM concentration shows two absorbance peaks with wavelength values of 265 nm and 416.5 nm. This also leads to a redshift of the GO absorbance peak with a wavelength of 252 nm to 265 nm resulting in reduction of GO (rGO) material. The SEM results of GO-AgNP samples do not show the presence of AgNP granules corresponding to the EDX results showing that the oxygen element has the highest percentage. The XRD results are shown by comparing the diffraction patterns of the GO-AgNP sample and that of GO sample. Furthermore FTIR results indicate the presence of C-H alkanes, C=O bonds, and O-H bonds in the GO-AgNP samples.
关键词： GO,XRD,FTIR,UV-Vis spectroscopy,GO-AgNP,AgNP,SEM-EDX
更新于2025-09-04 15:30:14
-
Investigation of structural, optical and morphological properties of InGaN/GaN structure
摘要： In this study, InGaN/GaN structure is investigated in the temperature range of 300–500?°C with steps of 50?°C. InGaN/GaN multi-quantum well structure is deposited on c-orientated sapphire wafer by metal organic chemical vapour deposition method. All the parameters except for temperature kept constant during growth period. InGaN/GaN structures with different In content are investigated by XRD technique. Their structural, optical and morphological characteristics are determined by high resolution X-ray diffraction, Fourier transform spectroscopy (FTIR), photo luminescence (PL), transmission and atomic force microscopy (AFM). According to FTIR and PL spectra’s, it is noticed that band gap values coincide with blue region in the electromagnetic spectrum. As a result of transmission measurements it is seen that light is completely absorbed by the sample at approximately 390?nm. Using XRD technique, dislocation densities and strain are calculated. Full width at half maximum of the XRD peak values gained from X-ray diffraction are used in an alternative method called William-son–Hall (W–H). Using W–H method, lateral and vertical crystal lengths and tilt angles are determined. Surface roughness parameters are investigated by AFM. Different properties of GaN and InGaN layers are compared as dependent on increasing temperature. According to AFM images it is seen that these structures have high surface roughness and large crystal size. All the results yielded from the mentioned methods are in good agreement with the previous works done by different authors.
关键词： FTIR,MOCVD,XRD,AFM,PL,InGaN/GaN
更新于2025-09-04 15:30:14
-
Laccase activity measurement by FTIR spectral fingerprinting
摘要： Laccases (EC 1.10.3.2) are enzymes known for their ability to catalyze the oxidation of phenolic compounds using molecular oxygen as the final electron acceptor. Laccase activity is commonly determined by monitoring spectrophotometric changes (absorbance) of the product or substrate during the enzymatic reaction. Fourier Transform Infrared Spectroscopy (FTIR) is a fast and versatile technique where spectral evolution profiling, i.e. assessment of the spectral changes of both substrate and products during enzymatic conversion in real time, can be used to assess enzymatic activity when combined with multivariate data analysis. We employed FTIR to monitor enzymatic oxidation of monolignols (sinapyl, coniferyl and p-coumaryl alcohol), sinapic acid, and sinapic aldehyde by four different laccases: three fungal laccases from Trametes versicolor, Trametes villosa and Ganoderma lucidum, respectively, and one bacterial laccase from Meiothermus ruber. By coupling the FTIR measurements with Parallel Factor Analysis (PARAFAC) we established a quantitative assay for assessing laccase activity. By combining PARAFAC modelling with Principal Component Analysis we show the usefulness of this technology as a multivariate tool able to compare and distinguish different laccase reaction patterns. We also demonstrate how the FTIR approach can be used to create a reference system for laccase activity comparison based on a relatively low number of measurements. Such a reference system has potential to function as a high-throughput method for comparing reaction pattern similarities and differences between laccases and hereby identify new and interesting enzyme candidates in large sampling pools.
关键词： FTIR,PARAFAC,enzyme activity assay,spectral evolution profiles,Laccase,high-throughput
更新于2025-09-04 15:30:14
-
Improved ATR-FTIR detection of hydrocarbons in water with semi-crystalline polyolefin coatings on ATR elements
摘要： In situ measurement of hydrocarbons in water is critical for assuring the safety and quality of drinking water and in environmental remediation activities such as the cleanup of oil spills. Thus, effective detection methods of hydrocarbons in aqueous environments are important and several methods have been used for this type of sensing, including spectroscopic techniques, fiber optic sensors, and chromatography. However, under aqueous conditions, small amounts of hydrocarbons are difficult to detect due to their low concentration in water and robust sensing of these types of compounds in an aqueous environment remains a challenging analytical task. Hydrophobic polymer coatings have been widely used to concentrate hydrocarbons for attenuated total reflection Fourier transform infrared spectroscopy (ATR-FTIR) detection at the surface of an ATR crystal by preventing water molecules from penetrating into the polymer coating while absorbing hydrocarbons. However, in typical coating designs only thin films (<5 μm) can be applied onto the ATR sensor due to the decrease in detection limit and sensitivity to hydrocarbons with increasing film thickness. This paper demonstrates that a semi-crystalline linear low-density polyethylene (LLDPE) polymer coating with thicker thickness (40 μm) can be applied effectively for in situ ATR-FTIR detection of hydrocarbons in aqueous solution. The ATR signal is enhanced by the polymer coating which swells in response to the hydrocarbons and prevents water accumulation at the IR detection interface. Coating the ATR element with a LLDPE film (crystallinity = 12%) reduced the detection time for various hydrocarbons, including toluene, benzene and chloroform. The detection limits and kinetics of the ATR-FTIR detection were not significantly altered when the thickness of the LLDPE coating was increased to improve its mechanical properties which represents a significant improvement from coatings published in the literature. The LLDPE coating described in this research has the potential to be applied as a sensor coating for rapid detection of hydrocarbon-based substances or non-polar biomolecules in aqueous environments.
关键词： LLDPE,water,hydrocarbons,ATR-FTIR,sensor
更新于2025-09-04 15:30:14
-
FTIR imaging of MCF-7 colonies and their vicinity in Matrigel-embedded 3D cultures
摘要： BACKGROUND: It is now recognized that tumor cells can actively alter their microenvironment and that this remodelled microenvironment can subsequently play a critical role in cancer progression and in?uence therapeutic responses. To date, the molecular heterogeneity within a 3D cancer cell colony and its in?uence on the extracellular matrix have not been studied by infrared imaging. OBJECTIVE: The objective of this study is to investigate by mid-infrared imaging 3D Matrigel-embedded colonies of pure MCF-7 human mammary adenocarcinoma cell line and the surrounding microenvironment after undergoing formalin ?xation and paraf?n embedding (FFPE). METHODS: In order to better reproduce the procedure used for preservation and storage of clinical tissue specimens for pathologic analysis, 7- and 10-day MCF-7 colonies embedded and grown in Matrigel were FFPE-treated; 4-μm-thick sections were cut, mounted on barium ?uoride window and deparaf?nized. The Fourier transform infrared (FTIR) images of 4096 spectra were collected in transmission mode using a FPA-based FTIR imaging system. They were pre-processed and analysed by principal component and K-mean cluster analyses. RESULTS: At 1654 cm?1 and 1234 cm?1, the intensity of absorption in the colonies is signi?cantly higher than in Matrigel. It can be also noted, on the one hand, that there is a spectral heterogeneity in the intracolonial distribution of the absorbances at 1654, 1644, 1640 and 1634 cm?1 (Amide I range) possibly due to changes in protein secondary structures. On the other hand, we observe that Matrigel close to MCF-7 colonies appears altered with respect to more distant Matrigel matrix. CONCLUSIONS: FTIR imaging allowed us to highlight changes in the chemical content in MCF-7 colonies and their direct vicinity in Matrigel-embedded 3D cultures.
关键词： extracellular matrix,FTIR imaging,3D cell culture
更新于2025-09-04 15:30:14
-
Calibration and instrumental line shape characterization of a set of portable FTIR spectrometers for detecting greenhouse gas emissions
摘要： A comprehensive calibration procedure for mobile, low-resolution, solar-absorption FTIR spectrometers, used for greenhouse gases observations, is developed. These instruments commend themselves for campaign use and deployment at remote sites. The instrumental line shape (ILS) of each spectrometer has been thoroughly characterized by analyzing the shape of H2O signatures in open path spectra. A setup for the external source is suggested and the invariance of derived ILS parameters with regard to chosen path length is demonstrated. The instrumental line shape characteristics of all spectrometers were found to be close to nominal. Side-by-side solar observations before and after a campaign, which involved shipping of all spectrometers to a selected target site and back, are applied for verifying the temporal invariability of instrumental characteristics and for deriving intercalibration factors for XCO2 and XCH4, which take into account residual differences of instrumental characteristics. An excellent level of agreement and stability was found between the different spectrometers: the uncorrected biases in XCO2 and XCH4 are smaller than 0.01 and 0.15 %, respectively, and the drifts are smaller than 0.005 and 0.035 %. As an additional sensitive demonstration of the instrumental performance we show the excellent agreement of ground pressure values obtained from the total column measurements of O2 and barometric records. We find a calibration factor of 0.9700 for the spectroscopic measurements in comparison to the barometric records and a very small scatter between the individual spectrometers (0.02 %). As a final calibration step, using a co-located TCCON (Total Carbon Column Observation Network) spectrometer as a reference, a common scaling factor has been derived for the XCO2 and XCH4 products, which ensures that the records are traceable to the WMO in situ scale.
关键词： calibration,XCO2,XCH4,FTIR spectrometers,instrumental line shape,greenhouse gas emissions
更新于2025-09-04 15:30:14