- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Enhanced Active Power balancing capability of Grid connected Solar PV fed Cascaded H-bridge Converter
摘要： Cascaded H-bridge converter is a promising solution for next generation large scale PV system having both active and reactive power exchange capacity. However, one challenge with this converter is unbalanced power generation among the clusters or cells due to variation in radiation level, temperature, dusting on PV cells etc. In order to inject balanced power to the grid, in this paper, a controlled exchange of reactive power is proposed so that the converter can work with unbalanced power generation within the clusters. Magnitude of reactive power exchange is derived and necessary conditions discussed. Additionally, the magnitude of zero voltage is derived taking into account both active and reactive power exchange with the grid. By exchanging reactive power, the converter can also be used during low voltage ride through (LVRT) condition. This paper introduces a novel representation of unbalanced power generation using barycentric coordinate system which helps to identify regions in the power plane which require the exchange of reactive power. The proposed method is verified through computer simulation and in a laboratory prototype.
关键词： Maximum Power point tracking (MPPT),Active power,Zero sequence voltage,Reactive power,Solar Photovoltaic,Cascaded H-bridge multilevel converter(CHB)
更新于2025-09-23 15:23:52
-
[IEEE 2018 International Conference on Power, Energy, Control and Transmission Systems (ICPECTS) - Chennai (2018.2.22-2018.2.23)] 2018 International Conference on Power, Energy, Control and Transmission Systems (ICPECTS) - Design and Hardware Implementation of Self Lift Negative Output Luo Converter Using MPPT for PV Applications
摘要： The design and analysis of self lift N/O luo converter is discussed in this paper. The incremental conductance mppt extracts the maximum power from PV panel and transfers to the load. The PV panel is designed by using equivalent circuit of PV cell. The output obtained from the solar panel contains more ripples. The ripples will produce more fluctuations. By using self lift negative output luo converter the unregulated output will be conveted into regulated voltage and stepped up to the higher voltage. For obtaining simulation results Matlab software is used.
关键词： Incremental conductance (IncCond) Maximum Power Point Tracking (MPPT) algorithm,self lift negative output luo converter,Photovoltaic system
更新于2025-09-23 15:23:52
-
A Novel Modified Sine-Cosine Optimized MPPT Algorithm for Grid Integrated PV System under Real Operating Conditions
摘要： This research work presents a modified sine-cosine optimized Maximum Power Point Tracking (MPPT) algorithm for grid integration. Developed algorithm provides a maximum power (PV) panel and simplified extraction implementation with benefit high convergence velocity. Moreover, the performance and ability of Modified Sine-Cosine Optimized (MSCO) algorithm equated with recent Particle Swarm Optimization (PSO) and Artificial Bee Colony (ABC) algorithms for comparative observation. Practical responses analyzed under steady state, dynamic and partial shading conditions by using dSPACE real controlling board laboratory scale hardware implementation. The MSCO based MPPT algorithm always shown the fast convergence rate, easy implementation, less computational burden and accurate to track the optimal PV power under varying weather conditions. Experimental results provided in the article clearly shown the validation of the proposed algorithm.
关键词： Maximum Power Point Tracking,Photovoltaic,Artificial Bee Colony,Particle Swarm Optimization,Sine-Cosine Optimized
更新于2025-09-23 15:23:52
-
[IEEE 2018 International Conference on Control, Power, Communication and Computing Technologies (ICCPCCT) - Kannur,Kerala, India (2018.3.23-2018.3.24)] 2018 International Conference on Control, Power, Communication and Computing Technologies (ICCPCCT) - MPPT Based SEPIC Converter With Voltage Doubler Cell For PV Systems
摘要： This article introduces “MPPT based SEPIC converter with voltage doubler cell for PV systems”. The primary aim of this study is to efficient energy conversion by utilizing SEPIC converter. The SEPIC converter accomplishes requirements like 1) Large transformation ratio with lesser number of elements. 2) Minimization of heavy stresses across switch. The description of operating principle of analysis is expressed within this article. The PV modeling along with MPPT algorithm and SEPIC converter for 250W are simulated in the MATLAB Simulink.
关键词： Maximum power point tracking (MPPT),Voltage doubler cell,SEPIC converter,Photovoltaic systems
更新于2025-09-23 15:23:52
-
[IEEE 2018 5th International Conference on Information Technology, Computer, and Electrical Engineering (ICITACEE) - Semarang, Indonesia (2018.9.27-2018.9.28)] 2018 5th International Conference on Information Technology, Computer, and Electrical Engineering (ICITACEE) - Maximum Power Tracking of Solar Panel using Modified Incremental Conductance Method
摘要： Static method to optimize a power delivered by a solar panel is called Maximum Power Point Tracking (MPPT). The method tries to find a maximum power from its PV solar panel characteristics curve using a power converter. MPPT is realized using a buck boost converter and Filter variable step size modified incremental conductance method. Experimental works show that the MPPT system successfully seeks its maximum power and decreases the oscillation during pathway to reach the maximum power. The power generated by the solar panels at 1000 watt/m2 (without MPPT) is 4.17 watt (R = 50 Ω) and 2.37 watts (R = 25 Ω). MPPT system can increase the power to solar panels into 4.48 watt (R = 50 Ω), and 4.32 watt (R = 25 Ω). The power generated by the solar panels at 750 watt/m2 (without MPPT) is 2.53 watt (R = 50 Ω) and 1.48 watts (R = 25 Ω). MPPT system designed also improve the power of solar panels into 3.02 watt (R = 50 Ω) and 3.02 watt (R = 25 Ω). The error steady state in the maximum power condition is 1.188%.
关键词： Maximum Power Point Tracking,Filter variable modified Incremental Conductance,Buck Boost Converter
更新于2025-09-23 15:23:52
-
[IEEE 2018 7th International Conference on Renewable Energy Research and Applications (ICRERA) - Paris, France (2018.10.14-2018.10.17)] 2018 7th International Conference on Renewable Energy Research and Applications (ICRERA) - Performance-Improved Maximum Power Point Tracking Control for PV System
摘要： Dc distribution systems are gaining attracted because of expanding the utilization of solar photovoltaic (PV) power. In such a situation, the design of the maximum power point tracking (MPPT) controllers should consider not only varying solar irradiance but also the dc bus voltage fluctuation. The purpose of this paper is to present a performance-improved MPPT controller using a derivative control to a PV panel voltage. The proposed method provides better performances than an existing reported method which uses the derivative control to a reactor current of a dc-dc converter. It is verified that the proposed method obtains quick responses to the rapid change of solar irradiance and dc bus voltage compared to conventional methods.
关键词： dc distribution system,dynamic response,PV system,maximum power point tracking (MPPT),dc-dc converter
更新于2025-09-23 15:23:52
-
Analysis of Nonlinear Dynamics of a Quadratic Boost Converter Used for Maximum Power Point Tracking in a Grid-Interlinked PV System
摘要： In this paper, the nonlinear dynamics of a PV-fed high-voltage-gain single-switch quadratic boost converter loaded by a grid-interlinked DC-AC inverter is explored in its parameter space. The control of the input port of the converter is designed using a resistive control approach ensuring stability at the slow time-scale. However, time-domain simulations, performed on a full-order circuit-level switched model implemented in PSIM c software, show that at relatively high irradiance levels, the system may exhibit undesired subharmonic instabilities at the fast time-scale. A model of the system is derived, and a closed-form expression is used for locating the subharmonic instability boundary in terms of parameters of different nature. The theoretical results are in remarkable agreement with the numerical simulations and experimental measurements using a laboratory prototype. The modeling method proposed and the results obtained can help in guiding the design of power conditioning converters for solar PV systems, as well as other similar structures for energy conversion systems.
关键词： subharmonic oscillations,DC-DC converters,maximum power point tracking (MPPT),nonlinear dynamics,photovoltaic (PV),quadratic boost
更新于2025-09-23 15:23:52
-
[IEEE 2018 International Conference on Current Trends towards Converging Technologies (ICCTCT) - Coimbatore (2018.3.1-2018.3.3)] 2018 International Conference on Current Trends towards Converging Technologies (ICCTCT) - Implementation of Differential Power Processing to Optimize the Solar Power Generation
摘要： The objective of this paper is to harvest the optimum power from solar panel using different MPPT techniques for low power application under non-uniform irradiance conditions. The overall power output of photovoltaic system is reduced due to partial shading. A new differential power converter along with INC control algorithm is introduced to reduce the partial shading effect and oscillations of output power.
关键词： Differential power processing,Maximum Power Point Tracking (MPPT) techniques,Photo-Voltaic (PV) array,Maximum Power Point (MPP),Partial Shading Condition (PSC)
更新于2025-09-23 15:22:29
-
[IEEE 2018 International Conference on Electronics, Control, Optimization and Computer Science (ICECOCS) - Kenitra, Morocco (2018.12.5-2018.12.6)] 2018 International Conference on Electronics, Control, Optimization and Computer Science (ICECOCS) - Backstepping Control for Three Phase Single Stage Grid Connected PV System with Improved Power Quality
摘要： The development of PV-systems has increased due to the high demand for clean energy. Used worldwide in the distributed power generation markets, the photovoltaic energy must not only be maximized, but also adapted to the global standards on harmonic emissions towards the power utility. Hence, the tracking of the maximum power point and the harmonic filtering becomes necessary. A three-phase single stage grid-connected Photovoltaic system consisting of a photovoltaic array and a three-phase PWM inverter coupled through the LCL-filter to the electrical grid is studied in this paper. A new control design is developed to maximize power in the side of PV panels and to ensure a unit power factor at the grid side. Grid synchronization is provided by a three-phase PLL (Phase-Locked Loop) and the closed-loop stability is demonstrated using Lyapunov analysis. Simulation results clearly illustrate that the proposed controller has achieved all of its objectives. In order to demonstrate the performance of the LCL-filter in minimizing the harmonics produced by the photovoltaic inverter, the frequency response of the injected currents was compared to that obtained using a simple L-filter.
关键词： backstepping controller,PV systems,maximum power point tracking,three-phase inverter,LCL-filter,unity power factor,grid connection
更新于2025-09-23 15:22:29
-
A Dual-Discrete Model Predictive Control-based MPPT for PV systems
摘要： This paper presents a method that overcomes the problem of the confusion during fast irradiance change in the classical MPPTs as well as in model predictive control (MPC)-based MPPTs available in the literature. The previously introduced MPC-based MPPTs take into account the model of the converter only, which make them prone to the drift during fast environmental conditions. Therefore, the model of the PV array is also considered in the proposed algorithm, which allows it to be prompt during rapid environmental condition changes. It takes into account multiple previous samples of power, and based on that is able to take the correct tracking decision when the predicted and measured power differ (in case of drift issue). After the tracking decision is taken, it will be sent to a second part of the algorithm as a reference. The second part is used for following the reference provided by the first part, where the pulses are sent directly to the converter, without a modulator or a linear controller. The proposed technique is validated experimentally by using a buck converter, fed by a PV simulator. The tracking efficiency is evaluated according to EN50530 standard in static and dynamic conditions. The experimental results show that the proposed MPC-MPPT is a quick and accurate tracker under very fast changing irradiance, while maintaining high tracking efficiency even under very low irradiance.
关键词： Buck converter,dc-dc power conversion,Photovoltaic systems,Double cost function,Maximum power point tracking,Drift,EN50530 standard,MPC
更新于2025-09-23 15:22:29