Abrasive flow machining (AFM) finishing of conformal cooling channels created by selective laser melting (SLM)

摘要： Conformal cooling channels are widely adopted in the mold industry because of rapid and uniform cooling during injection molding. These complicated cooling channel geometries become feasible via selective laser melting (SLM) technology. However, the SLM fabricated internal channel surface shows high surface roughness of about 10 μm Ra. This rough surface can cause stress concentration, reducing the fatigue life of the mold. Therefore, the objective of this study is to investigate the surface finish of the SLM fabricated conformal channels by abrasive flow machining (AFM), which is widely used in the surface finishing of internal channels. To fulfill this objective, a combination of single/multiple and straight/helical channels for conformal cooling channel geometries are employed. Seven different types of conformal cooling channels (?3mm) inside the bar are fabricated using SLM. The bar is put in the AFM fixture, and the internal channels are polished by flowing AFM media (ULV50%-54) through the channel at the same extrusion pressure of 80 bars for ten cycles. Fourteen bars (seven before AFM and seven after AFM) are machined to have the internal channel surfaces exposed for surface roughness measurement. Surface topographies of the exposed surfaces of seven types of internal channels are obtained using focus variation microscopy. The areal roughness parameters, such as arithmetical mean height (Sa) on the internal channel surfaces before and after AFM. By comparing SLM as-built conformal channel surfaces with AFM finished ones, AFM is shown to be effective in improving all SLM conformal cooling channels’ arithmetical mean height, Sa. Areal roughness parameters, such as developed interfacial area ratio (Sdr), root mean square gradient (Sdq), reduced peak height (Spk), reduced valley height (Svk), and skewness (Ssk), on those internal surfaces, were found to be sensitive to surface finishing by AFM.