- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
Microwave photonics‐based all optical wavelength conversion of Nyquist‐DP‐16QAM for flex‐grid optical networks with 112 Gbps
摘要： We propose and demonstrate an all optical wavelength conversion of Nyquist differential phase 16 quadrature amplitude modulation based on microwave photonics signal processing for flex-grid optical networks. By analyzing the mechanism of the microwave photonics and the components, multi-adjusting the parameters of wavelength tunable laser with smooth and adjustable optical intensity can be obtained. Then, the multi-channel photonic signals with the minimal guard space of 5 GHz can be obtained, which provide more than 20 flex-grids for optical transmission with transparent rate and format. The optical power of converted wavelengths, optical signal-to-noise ratio, error vector magnitude, and bit error rate (BER) are studied under the condition of different flex-grids, the frequencies of which are from 15 GHz to 36 GHz. The channel frequency spacing and amplitude of the converted wavelength can be dynamically adjusted via parameter configuration. Flex-grid spacing strategies and channel selecting strategies are given. The BER performance of all converted channels can fall below the forward error correction threshold of 3.8 × 10?3 by optimizing the optical power of the receiver end. The results show the tradeoff between the BER and the detected optical power of the receiver end. These research findings could provide solutions for spectrum allocation and routing selection when wavelength conversion is needed in optical links.
关键词： coherent communication,microwave photonics,wavelength conversion,flex-grid optical networks
更新于2025-09-23 15:22:29
-
Hardware-efficient Signal Processing Technologies for Coherent PON Systems
摘要： Future passive optical network (PON) systems supporting more than 50 Gb/s/λ present a challenge for the use of intensity modulation direct detection (IM-DD). Since coherent technology improves the receiver sensitivity over that of IM-DD, it is a promising candidate for 100 Gb/s or higher PON systems. Introducing hardware-efficient signal processing technologies tailored to PON systems will help render coherent technology suitable for PON systems. We here review hardware-efficient signal processing technologies suitable for PON systems. We introduce two types of simplified adaptive equalization (AEQ), one which sacrifices differential group delay compensation (DGDC), and another which sacrifices some chromatic dispersion compensation but does provide DGDC. Transmission experiments on a 100 Gb/s/λ-based coherent wavelength division multiplexing (WDM) PON system showed that simplified AEQ without DGDC and with DGDC exhibited only 0.2 dB and 1.4 dB penalty respectively, compared with conventional DSP. The additional penalty due to the maximum possible cumulative DGD was evaluated by numerical simulation. Conventional AEQ and the simplified AEQ with DGDC showed negligible penalty, but the simplified AEQ without DGDC showed a 1.4 dB penalty. We also introduce simplified carrier phase recovery (CPR) with inter-polarization phase offset estimation, and this showed the same performance as the conventional DSP, in both experiment and simulation. Taking these results into account, 100 Gb/s/λ-based coherent WDM PON systems with the simplified AEQs in combination with the simplified CPR were shown to be able to support the loss budget required for 8 ONU splits over an 80 km span of single mode fiber.
关键词： adaptive equalization (AEQ),5G mobile front haul (MFH),coherent communication,carrier phase recovery (CPR),100 Gb/s-class passive optical network (PON)
更新于2025-09-23 15:21:21
-
[IEEE 2019 18th International Conference on Optical Communications and Networks (ICOCN) - Huangshan, China (2019.8.5-2019.8.8)] 2019 18th International Conference on Optical Communications and Networks (ICOCN) - Industry Trends for 400 Gb/s and Beyond Applications
摘要： After the implementation of 100-Gb/s pluggable optics, the optical communications is marching towards 400-Gb/s era. We will review our recent demonstration and study for 400 Gb/s and beyond client and line side optical interconnect.
关键词： coherent communication,optical communications,400G Ethernet,direct detection,packet optics
更新于2025-09-16 10:30:52
-
Phase Noise Measurements and Performance of Lasers with Non-white FM Noise for Use in Digital Coherent Optical Systems
摘要： We measure the FM noise power spectral density of quantum-dot mode-locked lasers (QD-MLLs) and compare this to their measured linewidths as predictors of performance in a digital coherent system. We explain our observations in terms of the non-Lorentzian line shape of the source wherein linewidth is determined by the low frequency part of its FM noise. Investigation of system performance with simulations based on the measured phase sequences and back-to-back coherent transmission experiments, show that QD-MLLs with linewidths of several MHz can have comparable performance to that of a laser with only a few hundreds of kHz of Lorentzian linewidth, due to the non-white part of their FM noise. We show that spectral linewidths of lasers with similar spectral properties can underestimate their performance in coherent systems, regardless of the linewidth measurement technique used. We propose a “Lorentzian-equivalent linewidth” measure to characterize lasers with non-white FM noise and to estimate their impact in digital coherent optical systems. This measure is obtained from phase variations at frequencies higher than typical frequencies often used to characterize lasers with white FM noise, and comparable to the system baud. The proposed measure is shown to be a better predictor of system performance than the measured linewidth, for lasers with non-white FM noise. The impact of non-white FM noise on the optimization of carrier phase recovery and system performance is also discussed.
关键词： diode lasers,Coherent communication,optical fiber communication,mode-locked lasers
更新于2025-09-12 10:27:22
-
The Impact of Local Oscillator Frequency Jitter and Laser Linewidth to Ultra High Baud Rate Coherent Systems
摘要： Through theoretical analysis and simulation, we investigate the system impact due to a sinusoidal jitter tone and the resultant local oscillator (LO) laser linewidth requirement in ultra-high baud rate and long distance coherent optical systems. We also carried out experiments in 64Gbaud, dual-polarization (DP)-16QAM systems to verify the theoretical analysis and simulation. We have also obtained a jitter interference tolerance mask to qualify LO lasers. A jitter tone with a frequency lower than ~1MHz has a higher tolerance since it generally causes constant frequency or phase shift, which can be tracked by a receiver DSP. For a jitter tone with a frequency higher than ~1MHz, the tolerance becomes much tighter since the tone will affect laser lineshape and induce equalizer-enhanced phase noise (EEPN). Consequently, a jitter tone in the higher frequency region could severely affect the system performance. Theoretical analysis and numerical result illustrate that EVM2 due to the effect of laser linewidth and a sinusoidal jitter tone is proportional to the weighted sum of [Δν × Bs × L] and [Δfpp×Bs × L]2, where Δν is the laser linewidth, Bs is the baud rate, Δfpp is the laser peak-to-peak frequency deviation due to a sinusoidal jitter tone, and L is the fiber transmission length. This result is applicable for all orders of QAM constellations. The implication to future 100 Gbaud and beyond systems is delineated.
关键词： laser noise,Optical fiber communication,coherent communication
更新于2025-09-11 14:15:04
-
[IEEE 2019 Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC) - Munich, Germany (2019.6.23-2019.6.27)] 2019 Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC) - Photonic Chip-Based Soliton Microcomb Driven by a Compact Ultra-Low-Noise Laser
摘要： Photonics chip-based soliton microcombs have been used in many applications including LIDAR, spectroscopy, coherent communication and astronomical spectrometer calibration [1]. Current-initiated soliton microcombs have been demonstrated [2, 3] recently, signifying improvements in the fabrication of high-Q Si3N4 microresonators. However, both approaches suffer from limited input laser power, thus only demonstrated single-soliton at repetition rates above 149 GHz, which are challenging to detect with commercially available photodetectors. Here we demonstrate a single-soliton generation in 100-GHz-FSR Si3N4 microresonators fabricated using the photonic Damascene reflow process [4], yielding the intrinsic Q-factor exceeding 15 million [5]. Using a compact hybrid laser with narrow linewidth, low relative intensity noise (–160 dBc/Hz at foffset=100 kHz) and high output power up to 100 mW [6], different comb states are observed by simply changing the current of the laser diode, without the need of complex tuning mechanism such as a single sideband modulator [7]. As the laser noise is directly transferred to the soliton comb line, this low-noise laser can be utilized in applications where the phase noise is a critical parameter, e.g. low-noise microwave generation or coherent communication. The experimental setup shown in Fig. 1 (a) consists of an ULN laser operated by a current source and temperature controllers to tune its frequency and power. After the light is coupled into the Si3N4 photonic chip via double inverse nano tapers [8], the temperature of FBG/GC is changed to align the laser wavelength to the resonance of the microresonator. The laser diode current is increased (≈ 330 mA) until soliton existence range is sufficiently long. This is indicated by transmission signal directly observed after the chip on the photodetector (Fig. 1 c). Due to high-Q factor of the Si3N4, the soliton state can be accessed via simply frequency forward tuning [9], without the need of any complex soliton tuning mechanism. Further, different comb states are observed, i.e. modulation instability, multi-soliton state and single-soliton state, via laser diode current tuning. The coherence properties of the soliton-comb teeth is asserted by performing a heterodyne beatnote measurement using a reference laser with a short-time linewidth of 10 kHz (Fig. 1b). The soliton spectrum is fitted with a sech2 function corresponding to a 3 dB bandwidth of ≈19.3 nm and a ≈131.5 fs pulse.
关键词： astronomical spectrometer calibration,Photonics chip-based soliton microcombs,photonic Damascene reflow process,low-noise microwave generation,Si3N4 microresonators,LIDAR,compact hybrid laser,coherent communication,single-soliton generation,spectroscopy
更新于2025-09-11 14:15:04