摘要： One of the important strategies for designing pure organic dyes is to improve the electron donating abilities of dye donors hence increase the intramolecular potential energy difference. In order to quantify the electron-donating capacity of organic units, we firstly propose a parameter donation ability (DA) value for evaluating the electron DA of organic units via theoretical calculation, by using of several fragments such as coplanar dithiophenyl pyrrole, triphenylamine (TPA), phenothiazine (PTZ) and cyanoacetic acid (CA) which is the research objects here. Inspired by the DA values of the above organic fragments, dye PSD-9, PSA-10 and PST-11 were designed and synthesized. Cyclic voltammetric (CV) measurements show that the DA values of dye PSA-10 and PST-11’s donor increases when TPA and PTZ groups are introduced into PSD-9, hence HOMO level increases and the band-gap narrow down. This change is reflected in the absorption spectra: the maximum absorption wavelength of PSA-10 and PST-11 is 63 and 84 nm red-shifted compared with PSD-9. Similarly, the molar extinction coefficients of PSA-10 and PST-11 are increased by 34.7 × 103 and 14.7 × 103 M?1 cm?1, respectively. Combining a mesoporous titania film grafted by these dithiophenyl pyrrole dye with iodine electrolyte, an 4.2% and 4.8% power conversion effciency (PCE) is achieved for PSA-10 and PST-11 at an irradiance of the AM1.5G sunlight, with an significant increasing compared to PSD-9 with an PCE of 1.6%. The typical photocurrent density–voltage (J–V) test shows that the short circuit current of dye PSA-10 and PST-11 is much higher than that of PSD-9, which is the main reason for the improvement of PCE. The red-shift and stronger IPCE curve is the most advantageous evidence of the change of short circuit current. Furthermore, electrochemical impedance measurements is studied for exploring the changes of open-circuit voltage of PSA-10 and PST-11, the results infer that larger donor units and long alkyl chains can effectively increasing current density on photoanode, hence increase the open circuit voltage of the devices.