研究目的
Investigating the degradation mechanism of I-based perovskite under UV photocatalysis and developing a method to enhance the photostability and efficiency of perovskite solar cells without using UV filters.
研究成果
The introduction of a ClMPI with strong Pb-Cl bonds between SnO2 and I-based perovskite significantly improves the photostability and efficiency of perovskite solar cells, achieving a PCE of up to 21.01% and maintaining >94% of initial performance after 180 h under outdoor solar irradiation. This approach provides a method for achieving UV-filter-free, efficient, and photo-stable PSCs.
研究不足
The study did not detect the MAI phase through XRD measurements, leaving uncertainty about whether MAI will be decomposed further under photocatalysis. More studies are needed to reveal the exact final product of MAPbI3 under photocatalysis.
1：Experimental Design and Method Selection:
The study involved the preparation of a chlorine-rich mixed-halide perovskite interlayer (ClMPI) between SnO2 and I-based perovskite to protect against UV photocatalysis.
2：Sample Selection and Data Sources:
High-quality perovskite single crystals (MAPbI3, MAPbBr3, MAPbCl3) were synthesized and mixed with SnO2 nanoparticles for photocatalysis aging tests.
3：List of Experimental Equipment and Materials:
Instruments included XRD, XPS, AFM, ToF-SIMS, and solar simulators for device testing.
4：Experimental Procedures and Operational Workflow:
The ClMPI was formed through halide exchange between MAPbI3 and NH4Cl, followed by device fabrication and stability testing under various conditions.
5：Data Analysis Methods:
Performance parameters were analyzed using J-V curves, EQE spectra, and stability tests under UV and full spectrum illumination.
独家科研数据包，助您复现前沿成果，加速创新突破
获取完整内容-
SnO2
Used as an electron transport layer (ETL) in perovskite solar cells.
-
TiO2
Used as an electron transport layer (ETL) in perovskite solar cells.
-
MAPbI3
Used as a light absorption layer in perovskite solar cells.
-
MAPbBr3
Used in photocatalysis aging tests.
-
MAPbCl3
Used in photocatalysis aging tests.
-
NH4Cl
Used to form a chlorine-rich mixed-halide perovskite interlayer (ClMPI).
-
X-ray diffractometer
Used for XRD measurements to analyze the components of samples.
-
Atomic force microscope
Used for AFM imaging to analyze film surfaces.
-
X-ray photoelectron spectrometer
Used for XPS analysis to elucidate the effect of photocatalysis.
-
Time-of-flight secondary-ion mass spectrometer
Used for ToF-SIMS to probe the chemical composition throughout the device.
-
Solar simulator
Used for device testing under AM 1.5G illumination.
-
登录查看剩余9件设备及参数对照表
查看全部
