研究目的
To bridge the unsteady and steady mechanisms of underwater propulsion in nature and engineering by colocating their flapping and steady lifting surfaces in an outwardly conventional propulsor.
研究成果
The study successfully demonstrated the feasibility of integrating unsteady and steady mechanisms of underwater propulsion in a single propulsor. The slosh mode allowed for transient-free thrust reversal and fine control of thrust amplitude through fin twisting, while the prop mode exhibited transients during thrust reversal. The propulsor's performance suggests potential for animal-like motion control in underwater vehicles.
研究不足
The tow speeds are low and close to the minimum induced velocity required for thrust onset by the flapping mechanism. The Reynolds number and shaft input power are limited, and the propulsor's performance at higher speeds and Reynolds numbers was not tested.
1:Experimental Design and Method Selection:
The propulsor was designed to operate in both slosh and prop modes, allowing for the comparison of unsteady and steady mechanisms of lift production. The design includes fins that can twist along their span, enabling independent variation of roll, pitch, and twist in the slosh mode, and independent variation of rotational rate, fin pitch, and twist in the prop mode.
2:Sample Selection and Data Sources:
The propulsor was tested in a low-speed tow tank with the carriage containing a robust support for the propulsor. Measurements were taken over a range of tow speeds and fin parameters.
3:List of Experimental Equipment and Materials:
The propulsor was equipped with an ATI Delta IP68 US-50–150 load cell for force measurements. The fin drive mechanism included angular position sensors and limit switches. The fins were made of a two-component urethane casting elastomer.
4:Experimental Procedures and Operational Workflow:
The propulsor was tested in both slosh and prop modes under various conditions, including hovering and slow towing. The effects of fin twist and pitch amplitude on thrust were measured.
5:Data Analysis Methods:
Time-averaged measurements of thrust were compared between slosh and prop modes. Quasi-steady and steady models were used to calculate the effects of twist and pitch amplitudes in the towed case.
独家科研数据包,助您复现前沿成果,加速创新突破
获取完整内容