- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
[IEEE IECON 2019 - 45th Annual Conference of the IEEE Industrial Electronics Society - Lisbon, Portugal (2019.10.14-2019.10.17)] IECON 2019 - 45th Annual Conference of the IEEE Industrial Electronics Society - New Approaches for Low Power Photovoltaic Water Pumping Systems
摘要： Photovoltaic water pumping systems are available as kits to supply water where the grid does not go. These kits usually are made by multinationals and based on specific components, making the most of small and very small companies, who usually install these systems, dependent on others. Thankfully these companies can develop their own solutions with standard frequency converters and AC pumps. An alternative is to connect the standard frequency converters to a photovoltaic string with a DC voltage of the order of some hundreds of volts. This implies in more than 2kW of power installed. For many applications, more than 2kW would be oversized. This paper presents a review of photovoltaic water pumping systems based on standard frequency converters and proposes new approaches for low power applications requiring only up to four modules. These approaches are being investigated and evaluated in cooperation with a company.
关键词： Photovoltaic Pumping,AC Pumps,Boost Converter,Frequency Converter,Photovoltaic Energy
更新于2025-09-16 10:30:52
-
[IEEE 2019 2nd International Conference on Power Energy, Environment and Intelligent Control (PEEIC) - Greater Noida, India (2019.10.18-2019.10.19)] 2019 2nd International Conference on Power Energy, Environment and Intelligent Control (PEEIC) - Power Quality Enhancement of Soft Computing FLC MPPT Based Standalone Photovoltaic System
摘要： Single phase system has been secured with Photovoltaic system based on Fuzzy Logic Control based perturbed & observed (P&O) maximum power point tracking phenomenon with active power filter (APF) connected to a nonlinear load. The conventional Perturbed & Observed algorithm is used to achieve maximum power output from Photovoltaic array, Proportional Integral controller with positive sequence detector phase locked loop(PLL) synchronization are implemented to generate reference current. It is emplyed to generate switching signal for VSI in hysteresis band current controlled (HBCC). DC link of PWM converter is controlled with switch controlled of VSI inverter. In proposed work minimize harmonic distortion present in source current due to power electronic based nonlinear load. Total current harmonic distortion (THD) is reduced by shunt active power factor and power factor improve after compensation reactive power supplied by system reduce and active power of system increase. The system designed with MATLAB/SIMULINK 2015(a) platform.
关键词： Shunt Active Power Filter (SAPF),Photovoltaic Array (PVA),Maximum Power Point Tracking (MPPT),PWM Converter,Boost Converter,Fuzzy logic Control (FLC),Proportional Integral controller (PI)
更新于2025-09-16 10:30:52
-
[IEEE 2019 4th International Conference on Power Electronics and their Applications (ICPEA) - Elazig, Turkey (2019.9.25-2019.9.27)] 2019 4th International Conference on Power Electronics and their Applications (ICPEA) - Implementation of Incremental Conductance Based MPPT Algorithm for Photovoltaic System
摘要： This paper deals with the hardware implementation of incremental conductance (IncCond) algorithm based maximum power point tracking (MPPT) for a photovoltaic (PV) system using Arduino board. The considered system consists of a DC-DC Boost converter, a PV panel and a resistive load. Firstly, simulation tests using Matlab/Siumilink are provided and then experimental validation is conduced based on an Arduino uno and spatial Simulink package known as ”support package for Arduino hardware”. The simulation and experimental tests show the satis?ed results of IncCond algorithm in terms of extraction of the maximum power point(MPP) form PV panel.
关键词： Arduino Board,DC–DC Boost converter,Incremental conductance,MPPT
更新于2025-09-16 10:30:52
-
[IEEE 2018 2nd IEEE International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES) - Delhi, India (2018.10.22-2018.10.24)] 2018 2nd IEEE International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES) - A Modified Perturb & Observe Algorithm For Maximum Power Point Tracking With Zero Voltage Switching Buck Boost Converter in Photovoltaic System
摘要： The conventional perturb and observe algorithm used for maximum power point tracking of PV system suffers from major drawbacks such as steady state oscillation around final maximum power point and loss of tracking direction i.e. divergence from actual maximum power point for rapid change in insolation. Both these problems result in significant power loss as the PV system operating point is getting diverted from actual maximum power point. As Buck-Boost converter plays an important role while changing the operating point of PV panel, it contributes to significant amount of power loss in the form of switching loss, conduction loss etc. This paper proposes a method to avoid the above given shortcomings of perturb & observe algorithm. Major focus is given on the designing of Buck-Boost converter as to date nobody has taken into consideration the losses occurring in the converter even though converter forms an integral part of the MPPT set up. The losses occurring in the conventional buck boost converter have been computed and its effect on the efficiency of MPPT system is investigated. The soft-switched buck boost converter for PV applications is designed so as to minimize the losses taking place in converter.
关键词： Buck-boost converter,Perturb and observe (P&O),Photo voltaic (PV),Soft switching,Zero voltage switching (ZVS)
更新于2025-09-16 10:30:52
-
[IEEE 2019 Innovations in Power and Advanced Computing Technologies (i-PACT) - Vellore, India (2019.3.22-2019.3.23)] 2019 Innovations in Power and Advanced Computing Technologies (i-PACT) - A Generalized MPPT Controlled DC-DC Boost Converter for PV System Connected to Utility Grid
摘要： This paper presents a Generalized MPPT control based DC-DC boost converter to generate continuous power with its preserved dynamic control system. The PV array is modeled with algebraic loop to achieve accurate solution with iterations in large sample of times. The larger time steps are utilized in this model to obtain fast simulation. MPPT controller embedded with Generalized P and O technique in PV system to regulate duty cycle through which maximum continuous power will be obtained. The MPPT controller with proposed converter is designed in a strategy to extract continuous power regardless of irradiance and temperature. 100kW PV array connected 25kV utility grid is examined in MATLAB SIMULINK and compared with other models in available literature to show effectiveness of designed model.
关键词： MPPT controller,Boost Converter,PV System,PV array,P&O technique
更新于2025-09-16 10:30:52
-
AIP Conference Proceedings [AIP Publishing TECHNOLOGIES AND MATERIALS FOR RENEWABLE ENERGY, ENVIRONMENT AND SUSTAINABILITY: TMREES19Gr - Athens, Greece (4–6 September 2019)] TECHNOLOGIES AND MATERIALS FOR RENEWABLE ENERGY, ENVIRONMENT AND SUSTAINABILITY: TMREES19Gr - Comparative study on photovoltaic water pumping systems driven by direct current motor (DCM) and induction motor (IM) optimized with P&O control
摘要： This paper presents a comparison between two photovoltaic water pumping system driven by a separately excited DC motor (DCM) and an induction motor (IM), via a DC/DC buck-boost converter coupled to a centrifugal pump. The two systems are optimised by a P&O MPPT algorithm, which aims to the maximisation of the global efficiency, will lead consequently to maximize the drive speed and the water discharge rate of the coupled centrifugal pump. Each component of the PV water pumping system is studied and analyzed in MATLAB/SIMULINK. The two systems are then compared in terms of efficiency and quantity of water pumped per day. The study concludes that the IM-driven PV system yields highly favorable results and requires less maintenance compared with other systems.
关键词： photovoltaic water pumping,induction motor,DC/DC buck-boost converter,centrifugal pump
更新于2025-09-12 10:27:22
-
Variable Frequency Control of a Photovoltaic Boost Converter System with Power Quality Indexes Based on Dynamic Phasors
摘要： Dynamic phasors modeling technique has demonstrated to be a good methodology for modeling oscillatory dynamic systems such as electric machines, power electronics and FACTS. Its main advantages are accuracy and fast simulation. However, something that has not been much exploited, is that Fourier coefficients can be used to compute the voltage module at some specific frequency for example, and with this extra information design new control algorithms to improve the behavior of the system. In this work, an extended model of a PV-boost converter system is developed, considering the main harmonics of the system that appear for a wide range of operation. Then, with this extra information contained in the harmonics, two new approaches are proposed: 1) Design of a variable frequency control of the boost converter to improve the quality of the output voltage under irradiation and load changes, and 2) Definition of power quality indexes for monitoring oscillatory behavior. Simulation results demonstrate the proposal effectiveness, establishing the mathematical basis and analyzing the dynamics of a 12.8 kWp photovoltaic system under different scenarios of operation.
关键词： variable frequency control,Dynamic phasors modelling,PI controllers,photovoltaic boost converter,power quality indexes
更新于2025-09-12 10:27:22
-
[IEEE 2018 2nd IEEE International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES) - Delhi, India (2018.10.22-2018.10.24)] 2018 2nd IEEE International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES) - An ANFIS Artificial Technique Based Maximum Power Tracker for Standalone Photovoltaic Power Generation
摘要： This paper mainly develops a buck-boost converter based standalone photovoltaic system (PV) for power generation with maximum power point tracking (MPPT). Buck/boost converter is controlled by an adaptive neuro fuzzy inference system (ANFIS) MPPT algorithm which is programmed in a microcontroller. Inverter current controller using dSPACE DS1104 is performed for this purpose. Reliability and validity of standalone photovoltaic power generation system is justified using found Simulink and hardware results.
关键词： DC-DC buck boost converter,Standalone photovoltaic system,ANFIS,MPPT,dSPACE DS1104
更新于2025-09-12 10:27:22
-
Design of a Photovoltaic System with Ultracapacitor Energy Buffer
摘要： Global concerns over the damage caused to the environment by fossil fuels, as well as the instability of oil prices, has led to an increase interest in alternate electric power generation from renewable sources such as the sun, wind and geothermal energy. Solar energy is produced by solar panels which are made of materials having the capacity to create a flow of electric carriers when exposed to the solar irradiance. The efficiency of these panels depends on the sun light, and they cannot work at their maximum power point independently, hence, requiring Maximum Power Point Tracker (MPPT). This MPPT permits to compensate the changes in irradiance and temperature conditions and variations in load demands which cause power imbalances. As such, a photovoltaic system with supercapacitor energy buffer is designed using Psim software. The system consists of a photovoltaic array, a MPPT, a supercapacitor, and a charge controller which is to effectively balance and regulate power in the system.
关键词： Charge controller,Psim,Solar panel,Maximum Power Point Tracking,Buck-Boost converter,Ultracapacitor
更新于2025-09-12 10:27:22
-
Output current ripple reduction of LED driver using ceramic‐capacitor‐input circuit and buck‐boost converter
摘要： This article proposes an LED driver that consists of a ceramic-capacitor-input rectifier and a buck-boost converter. The LED driver has an advantage of long life because it does not contain any electrolytic capacitors. However, the issue with electrolytic capacitor-less LED driver is that the ripple of the smoothed voltage becomes large due to insufficient capacitance of the smoothing capacitor. The proposed method, which uses the discontinuous current mode of a buck-boost converter, reduces the output current ripple under such conditions. Experimental results using a 5.7 W LED driver prototype demonstrate that the proposed method reduces the output current ripple and that the percent flicker becomes 4.4%, which is smaller than the recommended upper limit of 8%.
关键词： ceramic capacitor,LED driver,buck-boost converter,electrolytic capacitor-less,discontinuous current mode
更新于2025-09-12 10:27:22