- 标题
- 摘要
- 关键词
- 实验方案
- 产品
-
High-throughput laser generation of Si-nanoparticle based surface coatings for antibacterial applications
摘要： High-productivity regime of nanosecond IR-laser ablative generation of silicon colloidal solutions in water for anti-bacterial applications was found in terms of GW/cm2-level laser intensity and scanning velocity by measuring multi-shot ablative mass loss and extinction coefficients of the colloids as sub-linear and third-power intensity functions, respectively. This advantageous regime implies sub-linear mass loss versus laser intensity at the simultaneous third-power yield of nanoparticles, resulting from the subcritical-density, opaque ablative plasma regulating the sample ablation rate and the related plasma-mediated dissociation (dispergation) of the ablation products. In contrast, at higher intensities, there is a drastic increase in mass loss with the corresponding increased yield of (sub) micrometer-sized particles owing to intense plasma-driven expulsion of micro-scale melt droplets and the corresponding saturation of the extinction coefficient of the colloidal solutions because of their dynamic local “self-limiting” effect during the high-rate ablation. The optimal low-intensity regime for Si nanoparticle production demonstrates the monotonous correlated increase of mass loss and extinction coefficient in terms of increasing laser scanning velocity, indicating the diminished cumulative effects. Surface coatings prepared from the generated Si nanoparticles exhibit minor surface oxidation, as acquired as their elemental composition via energy-dispersive X-ray spectroscopy, making their contact angle for water droplets (≈51°) close to that of bare Si wafer (≈58°) with its nanometer-thick native oxide layer. Owing to good wetting, the nanoparticle-based surface coatings show strong antibacterial response regarding Gram-negative Pseudomonas auereginosa bacteria even despite their minor oxidative passivation.
关键词： Silicon nanoparticles,Colloids,Surface oxidation,Extinction coefficient,Wetting,Antibacterial tests,Gram-negative bacteria Pseudomonas auereginosa,Sub-critical ablative plasma,Nanosecond laser ablation,Mass loss
更新于2025-09-23 15:21:21
-
The interaction between the osteosarcoma cell and stainless steel surface, modified by high-fluence, nanosecond laser pulses
摘要： The irradiation of metallic surfaces by high-fluence laser pulses in an oxygen-containing atmosphere inevitably modifies the surface topography, chemistry, and wettability. These modifications significantly influence cell-surface interactions and, consequently, surface biocompatibility. We investigate how surface texturing by high-fluence nanosecond laser pulses from a Nd:YAG laser (wavelength of 1064 nm) influences cell adhesion and morphology with the aim of assessing its impact on initial cell behaviour. Quantitative and qualitative analysis of osteosarcoma cell adhesion, viability, and cell morphology were evaluated after 24-hour exposure to non-treated and laser-textured stainless-steel (AISI 316L) surfaces by fluorescent and scanning electron microscopy. The results reveal that this, initial interaction between the cells and the laser-textured surfaces leads to round shaped cells with a smaller footprint. Contrarily, on the non-processed stainless-steel and control-glass surfaces the polygonal, highly elongated, and flattened cells are observed. The cells on the laser-textured surfaces are less dendritic, with short tubular protrusions and an overexpression of extracellular vesicles, which are rarely found on non-treated and control samples. This likely happens due to the formation of nanostructured, high-temperature oxides that are induced by laser ablation. The analysis by X-ray photoelectron spectroscopy reveals that the laser-textured stainless-steel surfaces contain Cr hexavalent oxide, which is more toxic than the native oxide layer on the non-processed samples.
关键词： MG63 cells,cell adhesion,Laser surface engineering,laser texturing,nanosecond-laser ablation
更新于2025-09-23 15:21:01
-
Formation of periodic superhydrophilic microstructures by infrared nanosecond laser processing of single-crystal silicon
摘要： The evolution of the morphology and composition of the single-crystal silicon surface irradiated by infrared and visible nanosecond laser pulses is investigated as a function of processing parameters (laser fluence, irradiation spot size, the number of pulses, background gas pressure and composition). Two types of periodic surface microstructures are obtained with IR (1064 nm) laser pulses in a narrow fluence range of 3-6 J/cm2. At a relatively low number of laser pulses applied, a grid of cleavage cracks is produced within the irradiation spot along the crystal orientation. With further Si irradiation, periodic microhillocks are formed in the nodes of the crack grid. Silicon surface with such microhillocks exhibits superhydrophilic properties which are retained during prolonged storage in air. The cracks are produced in any environment (including vacuum) but the microhillocks are observed only in the presence of oxygen. No periodic structures were observed with visible (532 nm) laser pulses. Mechanisms of nanosecond laser-induced periodic microstructure formation on silicon are discussed.
关键词： oxidation,superhydrophilicity,silicon,periodic microstructures,Nanosecond laser ablation,damage threshold
更新于2025-09-23 15:19:57